MIL-STD-2042-2 Fiber Optic Cable Topology Installation Standard Methods For Naval Ships Equipment Part 2 Of 7 PartsThis standard provides detailed methods for the installation of fiber optic cable topology equipment see 3.16, and optical fiber cable entry to fiber optic cable topology and other equipment.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70

MIL-STD-2042-2B(SH)

TABLE 2G1-II.  Nylon stuffing tube sizes for BOF cable.

TABLE 2G1-III.  Nylon stuffing tube data.

NOTE:    Angle and "Y" tubes are not defined for 7 and 19-tube BOF cables.

These stuffing tubes are not compatible with the 7 and 19-tube BOF

cables.

Step 2 - WARNING:  Wear safety glasses during deburring to avoid possible eye injury.

Inspect the hole in the enclosure and remove any burrs or irregularities using the deburring tool.

Step 3 - For steel enclosures where the roughness is greater than a 125 microinch finish (not required on aluminum enclosures), remove the paint using a paint scraper and clean the surface with emery paper approximately 13 mm (0.5 inch) wide around the hole on the exterior of the enclosure.  Apply one coat of primer, and allow to set.  Dust coat the surface with talc if the primer is not thoroughly dried at the

2G1-2                        METHOD 2G1