MIL-STD-2042-2 Fiber Optic Cable Topology Installation Standard Methods For Naval Ships Equipment Part 2 Of 7 PartsThis standard provides detailed methods for the installation of fiber optic cable topology equipment see 3.16, and optical fiber cable entry to fiber optic cable topology and other equipment.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70

MIL-STD-2042-2B(SH)

6. NOTES

(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)

6.1 Intended use. The methods for equipment mounting and cable entrance to equipment depicted in this standard practice are intended primarily for new construction; however, they are applicable for conversion or alteration of existing ships.

6.2 Issue of DODISS. When this standard practice is used in acquisition, the applicable issue of the DODISS must be cited in the solicitation (see 2.2.1 and

2.3).

6.3 Standard method designation. To simplify the usage of this standard practice, an alphanumeric designation system was developed to identify and locate a given method. The methods were grouped together by function as follows:

Group A: Conventional cable entrance to equipment via nylon stuffing tubes.

B: Conventional cable entrance to equipment via MCP.

C: Conventional cable and buffered fiber forming and shaping.

D: Splice assembly and alignment.

E: BOF tube furcation unit fabrication.

F: BOF tube furcation unit installation.

G: BOF cable entrance to equipment via nylon stuffing tubes.

H: BOF cable entrance to equipment via MCP.

I: BOF cable forming, routing, and shaping.

J: BOF tube end sealing.

Then the designation system was completed as follows:

2 B 1 -

Alternate procedure within method Method number within group Functional group

MIL-STD-2042 Part number

Thus, method 2B1 indicates there is no alternate procedure for method 1 of group B in Part 2 (MIL-STD-2042-2) of MIL-STD-2042.

6.4 Subject term (key word) listing.

Component

Entrance into equipment

Interconnection box

Interconnection box selection

Interconnection organization

Nameplates and marking

Splice assembly and alignment

6.5 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue, due to the extent of the changes.

Preparing activity: NAVY - SH

(Project SESS-0006)