MIL-STD-2042-2B(SH)
3.2 Procedure.
3.2.l Splice assembly.
Step l - Mix a small portion of the index matching gel on a clean surface according to the manufacturer's instructions provided (vacuuming is not required).
NOTE: The index matching gel provided may be a one-part gel that does not require mixing.
Step 2 - CAUTION: Opening the sleeve too much may damage the sleeve.
Adjust the splice alignment clip tool so that it opens the splice alignment clip just enough to insert the splice ferrules. Insert the tool tip into the alignment sleeve slot. Open the sleeve (see figure
2Dl-l).
Alignment clip
Alignment tool
FIGURE 2Dl-l. Opening alignment sleeve.
Step 3 - Dip one of the polished ferrule tips into the index matching gel and slide the ferrule into the alignment clip until the tip is approximately centered in the clip (see figure 2Dl-2).
2Dl-2 METHOD 2Dl
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business