MIL-STD-2042-6B(SH)
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The methods for testing depicted in this standard practice are intended to ensure the FOCT is properly installed during and after each phase of installation procedures.
6.2 Issue of DODISS. When this standard practice is used in acquisition, the applicable issue of DODISS must be cited in the solicitation (see 2.2.1).
6.3 Standard method designation. To simplify the usage of this standard practice, an alphanumeric designation system was developed to identify and locate a given method. The methods were grouped together by function as follows:
Group |
A: |
Visual inspection. |
B: |
Cable attenuation test. |
|
C: |
Cable assembly link loss test. |
|
D: |
Cable continuity test. |
E: Cable topology end-to-end attenuation test. F: Measurement quality jumper selection test
G: Heavy-duty connector mechanical pull test. H: BOF cable BB test.
I: BOF cable pressurization test.
J: BOF tube seal verification test.
K: Cable assembly return loss test.
L: Cable topology end-to-end return loss test.
Then the designation system was completed as follows:
6 B 1 -
Alternate procedures within method Method number within group Functional group
MIL-STD-2042 Part number
Thus, method 6B1 indicates there is no alternate procedure for method 1 of group B in Part 6 (MIL-STD-2042-6) of MIL-STD-2042.
6.4 Data requirements. Contracts, purchase orders and other procurement documents referencing this standard should require the delivery of the test data obtained in the conduct of these procedures.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business