MIL-STD-2042-1B(SH)
METHOD 1B1
CABLE JACKET REPAIR
1. SCOPE.
1.1 Scope. This method describes procedures for repairing the damaged outer jacket of an inboard conventional cable or a BOF cable, with Kevlar strength members intact.
2. REQUIRED EQUIPMENT AND MATERIALS.
2.1 The equipment and materials in the tables located in the applicable sections of this method shall be used to perform these procedures.
3. PROCEDURES.
3.1 Safety summary. The following safety precautions shall be observed:
a. Safety glasses shall be worn when handling bare fibers.
b. Do not touch the ends of the fiber as they may be razor sharp. Wash your hands after handling bare fiber.
c. Observe warnings and cautions on equipment and materials.
d. When visually inspecting an optical fiber, never stare into the end of a fiber connected to a laser source or LED.
e. Never look into the end of a BOF tube. Always wear approved safety glasses when handling BOF tubes that may be connected to a pressure source.
3.2 Procedure I. Method 1B1-1. Wraparound sleeve with rail closure.
3.2.1 The equipment and materials in table 1B1-I shall be used to perform this procedure.
TABLE 1B1-I. Equipment and materials.
Description |
Quantity |
Safety glasses |
1 |
Ruler |
1 |
Electricians knife |
1 |
Emery cloth (or fine file) |
As required |
Adhesive and sealant tape (Raychem Thermofit S1030 or equal) |
As required |
Repair sleeve (Raychem CRSM-x-1200 or equal) |
1 |
1B1-1
METHOD 1B1
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business